Von Hippel
From BUG Wiki
(Redirected from Von Hippel Module)
Gerber Files
Product Specifications
- Standard Module Interfaces Exposed:
- Standard USB Host connector
- All other interfaces available in 0.100" pin field; can be equipped with breakaway headers for connector/ribbon cable interface, or wires directly soldered
- I2C, multi-point digital control bus
- SPI, digital control bus
- 4-wire Serial port (in pin field; no DB9 connector)
- I2S, digital audio bus
- 4 GPIO (General Purpose I/O) digital lines, direct from Bug Base Unit CPU
- 1 Interrupt input to Bug Base Unit CPU
- 6 IOX (I/O Expander) digital lines, four with LED sites available
- Analog-to-Digital Converter:
- Suitable for sensor inputs
- 16-bit ADC
- Accessed and controlled over I2C bus
- Max rate of 15 samples/sec
- 4 analog inputs, can be configured as four single-ended or two differential pairs
- Input range GND to 5V
- Includes integrated temperature sensor
- Datasheet: LTC2487 - ADC (PDF)
- Digital-to-Analog Converter:
- Suitable for control outputs
- 8-bit DAC
- Accessed and controlled over I2C bus
- Max rate approximately 6k samples/sec (determined on I2C clock rate)
- 2 analog outputs with programmable attenuation
- Output range GND to 5V
- Datasheet: http://datasheets.maxim-ic.com/en/ds/MAX5820.pdf
- Power Supply:
- 5V power available in pin field
- User adjustable power supply included as well, output 1.25-4.5V, available in pin field
- Adjustable power supply is software programmable via the I2C bus with a non-volatile digital pot
- Datasheet: http://www.analog.com/static/imported-files/data_sheets/AD5259.pdf
